HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 339
Default, Views, Default level, Parameters, control-packet bfd-source
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 339 highlights
ipv6 route-static vpn-instance s-vpn-instance-name ipv6-address prefix-length { interface-type interface-number [ next-hop-address ] [ bfd { control-packet | echo-packet } | permanent ] | next-hop-address [ public ] [ bfd control-packet bfd-source ip-address | permanent ] | vpn-instance d-vpn-instance-name next-hop-address [ bfd control-packet bfd-source ip-address | permanent ] } [ preference preference-value ] [ tag tag-value ] [ description description-text ] undo ipv6 route-static vpn-instance s-vpn-instance-name ipv6-address prefix-length [ interface-type interface-number [ next-hop-address ] | next-hop-address [ public ] | vpn-instance d-vpn-instance-name next-hop-address ] [ preference preference-value ] Default No IPv6 static route is configured. Views System view Default level 2: System level Parameters ipv6-address prefix-length: Specifies the IPv6 address and prefix length. interface-type interface-number: Specifies an output interface by its type and number. If the output interface is an NBMA interface or broadcast interface (such as a VLAN interface), rather than a point-to-point (P2P) interface, the next hop address must be specified. next-hop-address: Specifies the next hop IPv6 address. bfd: Enables BFD to detect reachability of the static route's next hop. When the next hop is unreachable, the system immediately switches to the backup route. control-packet: Specifies the BFD control mode. bfd-source ipv6-address: Specifies the source IPv6 address of BFD packets. HP recommends that you specify the loopback interface address. echo-packet: Specifies the BFD echo mode. permanent: Specifies the IPv6 route as a permanent IPv6 static route. If the output interface is down, the permanent IPv6 static route is still active. public: Indicates the next hop is on the public network. vpn-instance d-vpn-instance-name: Specifies a destination MPLS L3VPN instance by its name, a case-sensitive string of 1 to 31 characters. If a destination VPN is specified, packets will search for the output interface based on the specified next hop (IPv6 address) for the static route. preference preference-value: Specifies a preference for IPv6 static routes, in the range of 1 to 255. The default is 60. tag tag-value: Sets a tag for marking the static route, in the range of 1 to 4294967295. The default is 0. Tags of routes are used for route control in routing policies. For more information about routing policies, see Layer 3-IP Routing Configuration Guide. description description-text: Configures a description for the IPv6 static route, which consists of 1 to 60 characters, including special characters like the space, but excluding the question mark (?). vpn-instance s-vpn-instance-name: Specifies a source MPLS L3VPN instance by its name, a case-sensitive string of 1 to 31 characters. Each VPN has its own routing table, and the configured static route is installed in the routing tables of the specified VPNs. 328