HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 275
network short-cut
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 275 highlights
# In BGP-VPN IPv6 unicast instance view, inject local network 2002::/64 to the IPv6 BGP routing table. system-view [Sysname] bgp 100 [Sysname-bgp] ip vpn-instance vpn1 [Sysname-bgp-vpn1] ipv6-family unicast [Sysname-bgp-ipv6-vpn1] network 2002:: 64 network short-cut Use network short-cut to increase the preference for a received EBGP route. This EBGP route is called shortcut route. Use undo network short-cut to cancel the configuration. Syntax In BGP IPv4 unicast instance view/BGP-VPN IPv4 unicast instance view: network ip-address [ mask | mask-length ] short-cut undo network ip-address [ mask | mask-length ] short-cut In BGP IPv6 unicast instance view/BGP-VPN IPv6 unicast instance view: network ipv6-address prefix-length short-cut undo network ipv6-address prefix-length short-cut Default A received EBGP route has a preference of 255. Views BGP IPv4 unicast instance view, BGP-VPN IPv4 unicast instance view, BGP IPv6 unicast instance view, BGP-VPN IPv6 unicast instance view Predefined user roles network-admin Parameters ip-address: Specifies an IPv4 network address. If the mask or mask-length is not specified, natural mask is used. mask: Specifies a mask of the network address in dotted decimal notation. mask-length: Specifies a mask length in the range of 0 to 32. ipv6-address: Specifies an IPv6 network address. prefix-length: Specifies a prefix length in the range of 0 to 128. Usage guidelines Different routing protocols might find different routes to the same destination. However, not all of those routes are optimal. For route selection, routing protocols, direct routes, and static routes are assigned different preferences. The route with the highest preference is preferred. By default, the preference of an EBGP route is lower than a local route. If a device has an EBGP route and a local route to reach the same destination, the device does not select the EBGP route. You can use the network shortcut command to configure the EBGP route to have the same preference as the local route so the EBGP route is more likely to become the optimal route. 264