HP 3100 HP LaserJet 3100 - Product User's Guide, C3948-90970 - Page 190

Message Cause Solution No Memory for Report Erase/Print Document Memory needed to print a report may be Print faxes that have been received to being used to store faxes that have been memory (see "Printing faxes received to received to memory. memory" in chapter 3). Needed memory may be being used to store faxes set up to be sent at a future time or to be polled. If you have several faxes set up to be sent at a future time or to be polled, try clearing these faxes using Job Status (see "Canceling a fax job using Job Status" in chapter 3). No Modem Installed There is a problem with the LIU. Unplug the power cord from the power source, wait 10 seconds, and replug in the power cord. If the error persists, service may be required. See the front of this manual for support information. No Room in Fax Log The fax log was unable to print due to an Load paper in the paper input bin so the error, such as out of paper. HP LaserJet 3100 product can print the log. Not Enough Memory There is not enough memory to complete Try resending the job. If the error the job indicated. persists, try reducing the amount of activity on the HP LaserJet 3100 product and cancel jobs in memory before resending the job. Not Enough Memory The HP LaserJet 3100 product does not to Duplicate for have enough memory to complete the COPY copy job. Divide the copy job into smaller sections and then try copying again. If you are collating the job, turn off the collation feature (chapter 8), only make one copy of the document at a time, or use the Document Assistant to make the copies. No Fax Pages in Memory to Reprint The HP LaserJet 3100 product attempted Wait for a fax, then as soon as a fax is in to execute "Reprint Last Fax" when the memory, the HP LaserJet 3100 nothing was in memory. product will reprint the fax. Nov-22-93 06:30 PM The battery inside the HP LaserJet 3100 You can continue to use the HP (An incorrect date product has failed, causing all Menu LaserJet 3100 product without the appears.) features to revert to the factory settings. battery, but if you re-enter the Menu Settings that contained alphabetic and settings and then turn off the power, the numeric characters you entered, such as settings are erased again. header information and speed-dial names To obtain service, you must contact and numbers, have been erased. HP's customer support center. See the front of this manual for support information. EN 9 Troubleshooting and Maintenance 189