Cisco IPS-4255-K9 Installation Guide - Page 109

Chapter 4 Installing the IPS 4270-20 Installing the IPS 4270-20 in the Rack Installing the Rail System Kit Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety: • This unit should be mounted at the bottom of the rack if it is the only unit in the rack. • When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack. • If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006 Warning This procedure requires two or more people to position the IPS 4270-20 on the slide assemblies before pushing it in to the rack. To install the IPS 4270-20 in the rack, follow these steps: Step 1 Attach the chassis side rail to the IPS 4270-20 by aligning the chassis rail to the stud on the IPS 4270-20, pressing the chassis side rail in to the stud, and then sliding the chassis side rail backwards until you hear the latch catch. 1 2 3 4 5 6 7 8 CiscoInIPtrSu4si2o7n0PSrEeRvIeEnStion Sensor UID SYSTEPMWR SMTGATMUTMS0GMT 1 250206 Note The tapered end of the chassis side rail should be at the back of the IPS 4270-20. The chassis side rail is held in place by the inner latch. Step 2 Repeat Step 1 for each chassis side rail. OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 4-17