Cisco IPS-4255-K9 Installation Guide - Page 132
Step 9, Caution, Installing the IPS
UPC - 746320951096
View all Cisco IPS-4255-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Removing and Replacing the Chassis Cover Step 9 Slide the chassis cover back and up to remove it. Chapter 4 Installing the IPS 4270-20 1 2 3 4 5 6 7 8 CiscoInIPtrSu4si2o7n0PSrEeRvIeEnStion Sensor UID SYSTEPMWR SMTGATMUMTSG0MT 1 250124 Caution Do not operate the IPS 4270-20 without the chassis cover installed. The chassis cover protects the internal components, prevents electrical shorts, and provides proper air flow for cooling the electronic components. Step 10 To replace the chassis cover, position it on top of the chassis and slide it on. Push down on the cover latch to lock into place. Note Make sure the chassis cover is securely locked in to place before powering up the IPS 4270-20. Step 11 Step 12 Step 13 Reattach the power cables to the IPS 4270-20. Reinstall the IPS 4270-20 in a rack, on a desktop, or on a table, or extend it back in to the rack. Power on the IPS 4270-20. For More Information • For the procedure extending the IPS 4270-20 from the rack, see Extending the IPS 4270-20 from the Rack, page 4-25. • For more information on working in an ESD-controlled environment, see Working in an ESD Environment, page 1-32. • For the IDM procedure for powering down the IPS 4270-20, refer to Rebooting the Sensor; for the IME procedure for powering down the IPS 4270-20, refer to Rebooting the Sensor. • For an illustration of the screwdriver and where it is located, see Figure 4-7 on page 4-9. • For the procedure for installing the power cables on the IPS 4270-20, see Installing the IPS 4270-20, page 4-35. • If you are reinstalling the IPS 4270-20 in a rack, see Installing the Rail System Kit, page 4-15. 4-40 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 OL-18504-01