Cisco IPS-4255-K9 Installation Guide - Page 267
Configuring the IDSM2 Maintenance Partition for Catalyst Software, Step 1
UPC - 746320951096
View all Cisco IPS-4255-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
Chapter 12 Upgrading, Downgrading, and Installing System Images Installing System Images • For the procedure for configuration the maintenance partition on IDMS-2, see Configuring the IDSM2 Maintenance Partition for Catalyst Software, page 12-31 and Configuring the IDSM2 Maintenance Partition for Cisco IOS Software, page 12-35. • For the procedure for initializing the IDSM2, see Advanced Setup for the IDSM2, page 10-20. Configuring the IDSM2 Maintenance Partition for Catalyst Software To configure the IDSM2 maintenance partition, follow these steps: Step 1 Step 2 Log in to the switch CLI. Enter privileged mode. console# enable console(enable)# Step 3 Reload the IDSM2. console> (enable) reset module_number cf:1 Step 4 Session to the IDSM2. console# session 9 Trying IDS-9... Connected to IDS-9. Escape character is '^]'. Cisco Maintenance image Note You cannot Telnet or SSH to the IDSM2 maintenance partition.You must session to it from the switch CLI. Step 5 Log in as user guest and password cisco. Note You can change the guest password, but we do not recommend it. If you forget the maintenance partition guest password, and you cannot log in to the IDSM2 application partition for some reason, the IDSM2 requires an RMA. login: guest Password: cisco Maintenance image version: 2.1(2) [email protected]# Step 6 View the IDSM2 maintenance partition host configuration. [email protected]# show ip IP address : 10.89.149.74 Subnet Mask : 255.255.255.128 IP Broadcast : 10.255.255.255 DNS Name : idsm2.localdomain Default Gateway : 10.89.149.126 Nameserver(s) : [email protected]# OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 12-31