Cisco IPS-4255-K9 Installation Guide - Page 263

Chapter 12 Upgrading, Downgrading, and Installing System Images Installing System Images Step 5 Image URL [tftp://0.0.0.0/]: tftp://10.89.146.1/IPS-SSM-K9-sys-1.1-a-7.0-1-E3.img Specify the command and control interface of the AIP SSM. Note The port IP address is the management IP address of the AIP SSM. Step 6 Step 7 Step 8 Port IP Address [0.0.0.0]: Example Port IP Address [0.0.0.0]: 10.89.149.231 Leave the VLAN ID at 0. VLAN ID [0]: Specify the default gateway of the AIP SSM. Gateway IP Address [0.0.0.0]: Example Gateway IP Address [0.0.0.0]: 10.89.149.254 Execute the recovery. asa# hw-module module 1 recover boot This transfers the image from the TFTP server to the AIP SSM and restarts it. Step 9 Periodically check the recovery until it is complete. Note The status reads Recovery during recovery and reads Up when reimaging is complete. asa# show module 1 Mod Card Type Model Serial No. 0 ASA 5540 Adaptive Security Appliance ASA5540 P2B00000019 1 ASA 5500 Series Security Services Module-20 ASA-SSM-20 P1D000004F4 Mod MAC Address Range Hw Version Fw Version Sw Version 0 000b.fcf8.7b1c to 000b.fcf8.7b20 0.2 1.0(7)2 7.0(0)82 1 000b.fcf8.011e to 000b.fcf8.011e 0.1 1.0(7)2 5.0(0.22)S129.0 Mod Status 0 Up Sys 1 Up asa# Note The Status field in the output indicates the operational status of the AIP SSM. An AIP SSM operating normally shows a status of "Up." While the adaptive security appliance transfers an application image to the AIP SSM, the Status field in the output reads "Recover." When the adaptive security appliance completes the image transfer and restarts the AIP SSM, the newly transferred image is running. OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 12-27