Cisco IPS-4255-K9 Installation Guide - Page 196

Basic Sensor Setup Chapter 10 Initializing the Sensor Step 9 Step 10 p. Enter yes if you want to use NTP. To use authenticated NTP, you need the NTP server IP address, the NTP key ID, and the NTP key value. If you do not have those at this time, you can configure NTP later. Otherwise, you can choose unauthenticated NTP. Enter off, partial, or full to participate in the SensorBase Network Participation. • Off-No data is contributed to the SensorBase Network. • Partial-Data is contributed to the SensorBase Network, but data considered potentially sensitive is filtered out and never sent. • Full-All data is contributed to the SensorBase Network. The SensorBase Network Participation disclaimer appears. It explains what is involved in participating in the SensorBase Network. Enter yes to participate in the SensorBase Network. The following configuration was entered. service host network-settings host-ip 10.89.143.126/24,10.89.143.254 host-name sensor126 telnet-option disabled access-list 10.0.0.0/8 ftp-timeout 300 no login-banner-text exit dns-primary-server enabled address 171.68.226.120 exit dns-secondary-server disabled dns-tertiary-server disabled http-proxy proxy-server address 128.107.241.170 port 8080 exit time-zone-settings offset -360 standard-time-zone-name CST exit summertime-option recurring offset 60 summertime-zone-name CDT start-summertime month march week-of-month second day-of-week sunday time-of-day 02:00:00 exit end-summertime month november week-of-month first day-of-week sunday time-of-day 02:00:00 exit exit ntp-option enabled ntp-keys 1 md5-key 8675309 ntp-servers 10.89.143.92 key-id 1 exit service global-correlation network-participation full exit 10-6 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 OL-18504-01