Cisco IPS-4255-K9 Installation Guide - Page 305

Chapter A Troubleshooting Troubleshooting the Appliance Step 3 Total Bytes Transmitted = 435730956 Total Transmit Errors = 0 Total Transmit FIFO Overruns = 0 sensor# The management interface is the interface in the list with the status line Media Type = TX. If the Link Status is Down, go to Step 3. If the Link Status is Up, go to Step 5. Make sure the sensor IP address is unique. sensor# setup --- System Configuration Dialog --- At any point you may enter a question mark '?' for help. User ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets '[]'. Current Configuration: service host network-settings host-ip 10.89.130.108/23,10.89.130.1 host-name sensor telnet-option enabled access-list 0.0.0.0/0 ftp-timeout 300 no login-banner-text exit --MORE-- Step 4 Step 5 If the management interface detects that another device on the network has the same IP address, it does not come up. Make sure the management port is connected to an active network connection. If the management port is not connected to an active network connection, the management interface does not come up. Make sure the IP address of the workstation that is trying to connect to the sensor is permitted in the sensor access list. sensor# setup --- System Configuration Dialog --- At any point you may enter a question mark '?' for help. User ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets '[]'. Current Configuration: service host network-settings host-ip 10.89.130.108/23,10.89.130.1 host-name sensor telnet-option enabled access-list 0.0.0.0/0 ftp-timeout 300 no login-banner-text exit --MORE-- If the workstation network address is permitted in the sensor access list, go to Step 6. OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 A-27