Cisco IPS-4255-K9 Installation Guide - Page 129
setup, Step 6
UPC - 746320951096
View all Cisco IPS-4255-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Chapter 4 Installing the IPS 4270-20 Installing the IPS 4270-20 Power connector Sensing interfaces Power connector PS2 PCI-E x4 9 PCI-E x8 8 7 PCI-E x4 PCI-E x8 6 5 PCI-E x4 4 3 PCI-X 100 MHz 2 1 PS1 250109 Reserved for Future Use UID CONSOLE MGMT10/0 Step 6 Step 7 Step 8 Step 9 Reserved Reserved Console port Management0/0 Attach the power cables (there are two power supplies) to the IPS 4270-20 and plug them in to a power source (a UPS is recommended). Power on the IPS 4270-20. Initialize the IPS 4270-20. Upgrade the IPS 4270-20 with the most recent Cisco IPS software. You are now ready to configure intrusion prevention on the IPS 4270-20. For More Information • For more information on working with electrical power and in an ESD environment, see Site and Safety Guidelines, page 1-30. • For more information on the best place to position your sensor on the network, see Your Network Topology, page 1-3. • For the procedure for installing the IPS 4270-20 in a rack, see Installing the IPS 4270-20 in the Rack, page 4-17. • For the instructions for setting up a terminal server, see Connecting an Appliance to a Terminal Server, page 1-19. • For the procedure for using the setup command to initialize the IPS 4270-20, see Initializing the Sensor, page 10-1. • For the procedure for obtaining the most recent Cisco IPS software, see Obtaining Cisco IPS Software, page 11-1. OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 4-37