Cisco IPS-4255-K9 Installation Guide - Page 214

Advanced Setup Chapter 10 Initializing the Sensor exit exit service analysis-engine virtual-sensor vs0 description Created via setup by user cisco signature-definition sig0 event-action-rules rules0 anomaly-detection anomaly-detection-name ad0 operational-mode inactive exit physical-interface GigabitEthernet0/8 subinterface-number 9 physical-interface GigabitEthernet0/8 subinterface-number 10 service event-action-rules rules0 overrides deny-packet-inline override-item-status Disabled risk-rating-range 90-100 exit [0] Go to the command prompt without saving this config. [1] Return back to the setup without saving this config. [2] Save this configuration and exit setup. Step 20 Enter 2 to save the configuration. Enter your selection[2]: 2 Configuration Saved. Step 21 Reboot the IDSM2. IDSM2# reset Warning: Executing this command will stop all applications and reboot the node. Continue with reset? []: Step 22 Step 23 Enter yes to continue the reboot. Apply the most recent service pack and signature update. You are now ready to configure the IDSM2 for intrusion prevention. For More Information • For the procedure for obtaining the most recent IPS software, see Obtaining Cisco IPS Software, page 11-1. • For the procedure for using HTTPS to log in to IDM, refer to Logging In to IDM. • For the procedures for configuring intrusion prevention on your sensor, refer to the following guides: - Installing and Using Cisco Intrusion Prevention System Device Manager 7.0 - Installing and Using Cisco Intrusion Prevention System Manager Express 7.0 - Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface 7.0 10-24 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 OL-18504-01