Cisco IPS-4255-K9 Installation Guide - Page 352

Gathering Information Chapter A Troubleshooting Total Broadcast Packets Transmitted = 0 Total Jumbo Packets Transmitted = 0 Total Undersize Packets Transmitted = 0 Total Transmit Errors = 0 Total Transmit FIFO Overruns = 0 MAC statistics from interface Management0/0 Interface function = Command-control interface --MORE-- Version Information The show version command is useful for obtaining sensor information. This section describes the show version command, and contains the following topics: • Understanding the show version Command, page A-74 • Displaying Version Information, page A-74 Understanding the show version Command The show version command shows the basic sensor information and can indicate where a failure is occurring. It gives the following information: • Which applications are running • Versions of the applications • Disk and memory usage • Upgrade history of the applications Note To get the same information from IDM, choose Monitoring > Sensor Monitoring > Support Information > Diagnostics Report. To get the same information from IME, choose Configuration > sensor_name > Sensor Monitoring > Support Information > Diagnostics Report. Displaying Version Information Use the show version command to display version information for all installed operating system packages, signature packages, and IPS processes running on the system. To view the configuration for the entire system, use the more current-config command. To display the version and configuration, follow these steps: Step 1 Step 2 Log in to the CLI. View version information. sensor# show version Application Partition: Cisco Intrusion Prevention System, Version 7.0(1)E3 Host: Realm Keys Signature Definition: Signature Update key1.0 S383.0 2009-02-20 A-74 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 OL-18504-01