Cisco IPS-4255-K9 Installation Guide - Page 169
Cisco IOS Software, Resetting the IDSM2, Catalyst Software
UPC - 746320951096
View all Cisco IPS-4255-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Chapter 7 Installing the IDSM2 Resetting the IDSM2 The set boot device command can either contain cf:1 or hdd:1. Step 4 Reset the IDSM2. The full memory test runs. Note A full memory test takes more time to complete than a partial memory test. Cisco IOS Software Use the hw-module module module_number reset mem-test-full command to enable a full memory test. The full memory test takes about 12 minutes. To enable a full memory test, follow these steps: Step 1 Step 2 Step 3 Log in to the console. Enable the full memory test. router# hw-module module 9 reset mem-test-full Device BOOT variable for reset = Warning: Device list is not verified. Proceed with reload of module?[confirm] % reset issued for module 9 router# Reset the IDSM2. The full memory test runs. Note A full memory test takes more time to complete than a partial memory test. Resetting the IDSM2 If for some reason you cannot communicate with the IDSM2 through SSH, Telnet, or the switch session command, you must reset the IDSM2 from the switch console. The reset process requires several minutes. This section describes how to reset the IDSM2, and contains the following topics: • Catalyst Software, page 7-13 • Cisco IOS Software, page 7-14 Catalyst Software To reset the IDSM2 from the CLI, follow these steps: Step 1 Step 2 Log in to the console. Enter privileged mode. console> enable OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 7-13