Cisco IPS-4255-K9 Installation Guide - Page 206

Advanced Setup Chapter 10 Initializing the Sensor Step 16 Apply the most recent service pack and signature update. You are now ready to configure the AIM IPS for intrusion prevention. For More Information • For the procedure for obtaining the most recent IPS software, see Obtaining Cisco IPS Software, page 11-1. • For the procedure for using HTTPS to log in to IDM, refer to Logging In to IDM. • For the procedures for configuring intrusion prevention on your sensor, refer to the following guides: - Installing and Using Cisco Intrusion Prevention System Device Manager 7.0 - Installing and Using Cisco Intrusion Prevention System Manager Express 7.0 - Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface 7.0 Advanced Setup for the AIP SSM To continue with advanced setup for the AIP SSM, follow these steps: Step 1 Step 2 Step 3 Step 4 Step 5 Session in to the AIP SSM using an account with administrator privileges. asa# session 1 Enter the setup command. The System Configuration Dialog is displayed. Enter 3 to access advanced setup. Specify the Telnet server status. You can disable or enable Telnet services. The default is disabled. Specify the web server port. The web server port is the TCP port used by the web server (1 to 65535). The default is 443. Note The web server is configured to use TLS/SSL encryption by default. Setting the port to 80 does not disable the encryption. Step 6 Step 7 Enter yes to modify the interface and virtual sensor configuration. Current interface configuration Command control: GigabitEthernet0/0 Unassigned: Monitored: GigabitEthernet0/1 Virtual Sensor: vs0 Anomaly Detection: ad0 Event Action Rules: rules0 Signature Definitions: sig0 [1] Edit Interface Configuration [2] Edit Virtual Sensor Configuration [3] Display configuration Option: Enter 1 to edit the interface configuration. 10-16 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 OL-18504-01