Cisco IPS-4255-K9 Installation Guide - Page 59

Chapter 2 Installing the IPS 4240 and the IPS 4255 Connecting the IPS 4240 to a Cisco 7200 Series Router Connecting the IPS 4240 to a Cisco 7200 Series Router When an IPS 4240 is connected directly to a 7200 series router and both the IPS 4240 and the router interfaces are hard-coded to speed 100 with duplex Full, the connection does not work. If you set the IPS 4240 to speed Auto and duplex Auto, it connects to the router but only at speed 100 and duplex Half. To connect correctly at speed 100 and duplex Full, set the interfaces of both the IPS 4240 and the router to speed Auto and duplex Auto. Also, if either interface is hard-coded, you must make the connection using a crossover cable. Accessories The IPS 4240 and the IPS 4255 accessories kit contains the following: • DB25 connector • DB9 connector • Rack mounting kit-screws, washers, and metal bracket • RJ45 console cable • Two 6-ft Ethernet cables Important Safety Instructions Warning IMPORTANT SAFETY INSTRUCTIONS This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety warnings that accompanied this device. Statement 1071 SAVE THESE INSTRUCTIONS Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030 OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 2-5