Cisco IPS-4255-K9 Installation Guide - Page 314
For the procedure for installing the sensor properly, refer to your sensor in this document.
UPC - 746320951096
View all Cisco IPS-4255-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 314 highlights
Troubleshooting the Appliance Chapter A Troubleshooting Step 4 sensor# configure terminal sensor(config)# service interface sensor(config-int)# physical-interfaces GigabitEthernet0/1 sensor(config-int-phy)# admin-state enabled sensor(config-int-phy)# show settings name: GigabitEthernet0/1 media-type: tx description: admin-state: enabled default: disabled duplex: auto speed: auto alt-tcp-reset-interface none sensor(config-int-phy)# Check to see that the interface is up and receiving packets. sensor# show interfaces MAC statistics from interface GigabitEthernet0/1 Media Type = TX Missed Packet Percentage = 0 Inline Mode = Unpaired Pair Status = N/A Link Status = Up Link Speed = Auto_100 Link Duplex = Auto_Full Total Packets Received = 3 Total Bytes Received = 900 Total Multicast Packets Received = 3 Total Broadcast Packets Received = 0 Total Jumbo Packets Received = 0 Total Undersize Packets Received = 0 Total Receive Errors = 0 Total Receive FIFO Overruns = 0 Total Packets Transmitted = 0 Total Bytes Transmitted = 0 Total Multicast Packets Transmitted = 0 Total Broadcast Packets Transmitted = 0 Total Jumbo Packets Transmitted = 0 Total Undersize Packets Transmitted = 0 Total Transmit Errors = 0 Total Transmit FIFO Overruns = 0 ... For More Information For the procedure for installing the sensor properly, refer to your sensor chapter in this document. A-36 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 OL-18504-01