Cisco IPS-4255-K9 Installation Guide - Page 271

Chapter 12 Upgrading, Downgrading, and Installing System Images Installing System Images Configuring the IDSM2 Maintenance Partition for Cisco IOS Software To configure the IDSM2 maintenance partition, follow these steps: Step 1 Step 2 Log in to the switch CLI. Session to the IDSM2. router# session slot 11 processor 1 The default escape character is Ctrl-^, then x. You can also type 'exit' at the remote prompt to end the session Trying 127.0.0.111 ... Open Cisco Maintenance image Note You cannot Telnet or SSH to the IDSM2 maintenance partition.You must session to it from the switch CLI. Step 3 Log in as user guest and password cisco. Note You can change the guest password, but we do not recommend it. If you forget the maintenance partition guest password, and you cannot log in to the IDSM2 application partition for some reason, you will have to RMA the IDSM2. login: guest password: cisco Maintenance image version: 2.1(2) [email protected]# Step 4 View the maintenance partition host configuration. [email protected]# show ip IP address : 10.89.149.74 Subnet Mask : 255.255.255.128 IP Broadcast : 10.255.255.255 DNS Name : idsm2.localdomain Default Gateway : 10.89.149.126 Nameserver(s) : [email protected]# Step 5 Clear the maintenance partition host configuration (ip address, gateway, hostname). [email protected]# clear ip [email protected]# show ip IP address : 0.0.0.0 Subnet Mask : 0.0.0.0 IP Broadcast : 0.0.0.0 DNS Name : localhost.localdomain Default Gateway : 0.0.0.0 Nameserver(s) : [email protected]# OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 12-35