Cisco IPS-4255-K9 Installation Guide - Page 253

Chapter 12 Upgrading, Downgrading, and Installing System Images Installing System Images The variables have the following definitions: • Address-Local IP address of the IPS 4240 • Server-TFTP server IP address where the application image is stored • Gateway-Gateway IP address used by the IPS 4240 • Port-Ethernet interface used for the IPS 4240 management • VLAN-VLAN ID number (leave as untagged) • Image-System image file/path name • Config-Unused by these platforms Note Not all values are required to establish network connectivity. The address, server, gateway, and image values are required. If you are not sure of the settings needed for your local environment, contact your system administrator. Step 5 If necessary, change the interface used for the TFTP download. Note The default interface used for TFTP downloads is Management0/0, which corresponds to the MGMT interface of the IPS 4240. Step 6 rommon> PORT=interface_name If necessary, assign an IP address for the local port on the IPS 4240. rommon> ADDRESS=ip_address Note Use the same IP address that is assigned to the IPS 4240. Step 7 If necessary, assign the TFTP server IP address. rommon> SERVER=ip_address Step 8 If necessary, assign the gateway IP address. rommon> GATEWAY=ip_address Step 9 Verify that you have access to the TFTP server by pinging it from your local Ethernet port with one of the following commands. rommon> ping server_ip_address rommon> ping server Step 10 If necessary define the path and filename on the TFTP file server from which you are downloading the image. rommon> IMAGE=path/file_name Caution Make sure that you enter the IMAGE command in all uppercase. You can enter the other ROMMON commands in either lower case or upper case, but the IMAGE command specifically must be all uppercase. OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 12-17