Cisco IPS-4255-K9 Installation Guide - Page 177

Chapter 8 Installing the NME IPS Installation and Removal Instructions For More Information • For more information on the IPS CLI, refer to Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface 7.0. • For more information on IDM, refer to Installing and Using Cisco Intrusion Prevention System Device Manager 7.0. • For IME, refer to Installing and Using Cisco Intrusion Prevention System Manager Express 7.0. Installation and Removal Instructions For instructions on how to install and remove the NME IPS, refer to Installing Cisco Network Modules in Cisco Access Routers. To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect the NME IPS only to intrabuilding or nonexposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends. For More Information • For the procedure for verifying that the NME IPS is installed properly, see Verifying Installation, page 8-6. • For the procedure for using the setup command to initialize the NME IPS, see Initializing the Sensor, page 10-1. • For more information about obtaining the most recent Cisco IPS software, see Obtaining Cisco IPS Software, page 11-1. • For the procedure to configure the NME IPS to receive IPS traffic, refer to Setting Up Interfaces on the NME IPS and the Router. • For the procedure for using HTTPS to log in to IDM, refer to Logging In to IDM. • For the procedures for configuring intrusion prevention on your sensor, refer to the following guides: - Installing and Using Cisco Intrusion Prevention System Device Manager 7.0 - Installing and Using Cisco Intrusion Prevention System Manager Express 7.0 - Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface 7.0 OL-18504-01 Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 8-5