Brother International PEDESIGN 7.0 Users Manual - English - Page 227

Manually Creating Embroidery Patterns From Images (Design Center) Programmable fill stitch Under sewing Sets underlay stitching on or off. Try to use underlay stitching for wide areas, in order to prevent shrinking during stitching. On: Underlay stitching will be sewn. Off: Underlay stitching will not be sewn. Default: Off [Type] Specifies the type of underlay stitching sewn. Single: Double: Single: Sews perpendicular to the specified sewing direction. Double: Sews a pattern at a 45° angle to the specified sewing direction. Density Sets the number of lines per millimeter. Range: 1.0 - 7.0 lines per mm (25 - 178 lines per inch) Default: 4.5 lines per mm (114 lines per inch) Gradation Sets the density gradation setting on or off. Available when the type of sewing direction is set to Constant. Click Pattern to set the gradation pattern and its density. Default: Off For details on this attribute, refer to"Creating a gradation" on page 225. Direction [Type] Specifies the type of sewing direction. Constant: Sews at a fixed angle. The angle is specified by the angle setting. Variable: Varies the sewing direction according to the region being sewn. [Angle] Specifies the sewing angle. Available only when the sewing direction type is set to Constant. 135° 90° 45° 180° 0° Range: 0 - 359 degrees Default: 45 degrees 225° 315° 270° Half Stitch Sets half stitching on or off. Available when the type of sewing direction is set to Vari- On: able. If one side of the fill stitching is dense, a half stitch could be sewn automatically to provide a more even density. Off: Default: Off Running Stitch Path Sets the running path of the stitching. Available when the type of sewing direction is set to Constant. Available settings: • Inside of region (shortest route) • Along outline (along the inner side) • Onto outline (on the outline) The inside of region setting is available only when the Gradation check box is cleared. Default: Inside of region Inside of region: Along outline: Onto outline: Pull Compensation Lengthens the sewing region in the stitch pattern's sewing direction to prevent pattern shrinkage during sewing. Range: 0.0 - 2.0 mm (0.00 - 0.08 inch) Default: 0.0 mm (0.00 inch) 221