Netgear M4100-26G CLI Manual - Page 170

ProSafe M4100 and M7100 Managed Switches set mld querier election participate Use this command to enable the Snooping Querier to participate in the Querier Election process when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier finds that the other Querier's source address is better (less) than the Snooping Querier's address, it stops sending periodic queries. If the Snooping Querier wins the election, then it will continue sending periodic queries. Default Format Mode disabled set mld querier election participate VLAN Config no set mld querier election participate Use this command to set the snooping querier not to participate in querier election, but go into a non-querier mode as soon as it discovers the presence of another querier in the same VLAN. Format Mode no set mld querier election participate VLAN Config show mldsnooping querier Use this command to display MLD Snooping Querier information. Configured information is displayed whether or not MLD Snooping Querier is enabled. Format Mode show mldsnooping querier [{detail | vlan }] Privileged EXEC When the optional arguments vlandid are not used, the command displays the following information. Field Description Admin Mode Indicates whether or not MLD Snooping Querier is active on the switch. Admin Version Indicates the version of MLD that will be used while sending out the queries. This is defaulted to MLD v1 and it cannot be changed. Querier Address Shows the IP address which will be used in the IPv6 header while sending out MLD queries. It can be configured using the appropriate command. Query Interval Shows the amount of time in seconds that a Snooping Querier waits before sending out the periodic general query. Querier Timeout Displays the amount of time to wait in the Non-Querier operational state before moving to a Querier state. Switching Commands 170