Netgear M4100-26G CLI Manual - Page 611

ProSafe M4100 and M7100 Managed Switches Term Definition Last Conflicting MAC Address The MAC Address of the conflicting host that was last detected on any interface. Time Since Conflict Detected The time in days, hours, minutes and seconds since the last address conflict was detected. clear ip address-conflict-detect This command clears the detected address conflict status information. Format Mode clear ip address-conflict-detect Privileged EXEC Link Local Protocol Filtering Commands Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary protocols running on standards-based switches. If certain protocol PDUs cause unexpected results, LLPF can be enabled to prevent those protocol PDUs from being processed by the switch. These commands are not supported on M4100 switches. llpf blockall Use this command to block LLPF protocol(s) on a port. Use blockall to filter all PDUs with a DMAC of 01:00:00:0C:CC:CX on the interface. Use blockisdp to filter the ISDP packets on the interface. Use blockvtp to filter the VTP packets on the interface. Use blockdtp to filter the DTP packets on the interface. Use blockudld to filter the UDLD packets on the interface. Use blockpagp to filter the PAGP packets on the interface. Use blocksstp to filter the SSTP packets on the interface. Format Mode Default llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp | blocksstp | blockall } Interface Config Disable no llpf Use this command to unblock LLPF protocol(s) on a port. Utility Commands 611