Netgear M4100-26G CLI Manual - Page 491
auto-voip {protocol-based | oui-based}, auto-voip oui
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 491 highlights
ProSafe M4100 and M7100 Managed Switches In a VoIP system, various signaling protocols are used to establish the connection between two VoIP devices. The supported signaling protocols are SIP, H.323, and SCCP. OUI-based Auto VoIP The OUI-based Auto VoIP feature prioritizes VoIP packets based on the OUI bytes in the source MAC address. A default list of OUIs is maintained. User is also allowed to configure OUIs that need prioritization apart from the default OUI list. Up to 128 OUIs are allowed on the device or system, including the default OUIs. Note: If voice VLAN and Auto-VoIP are enabled at the same time, one of them is operational. If the connected phone is LLDP-MED capable, voice VLAN has precedence over the Auto VoIP and Auto VoIP is operational if the phone does not support LLDP-MED. auto-voip {protocol-based | oui-based} This command is used to configure auto VoIP mode. The supported modes are protocol-based and oui-based. Protocol-based auto VoIP prioritizes the voice data based on the layer 4 port used for the voice session. OUI-based auto VOIP prioritizes the phone traffic based on the known OUI of the phone. Format Mode Default auto-voip {protocol-based | oui-based} • Global Config • Interface Config oui-based no auto-voip {protocol-based | oui-based} This command is used to set default mode. Format Mode no auto-voip {protocol-based | oui-based} • Global Config • Interface Config auto-voip oui This command is used to configure an OUI for Auto VoIP. The traffic from the configured OUI will get the highest priority over the other traffic. Format Mode Default auto-voip oui oui-desc Global Config A list of known OUIs is present Quality of Service (QoS) Commands 491