Netgear M4100-26G CLI Manual - Page 460
match srcip6, match srcl4port, match vlan, To specify the match condition as a numeric value
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 460 highlights
ProSafe M4100 and M7100 Managed Switches parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits. Default Format Mode none match srcip Class-Map Config match srcip6 This command adds to the specified class definition a match condition based on the source IP address of a packet. Default Format Mode none match srcip6 Ipv6-Class-Map Config match srcl4port This command adds to the specified class definition a match condition based on the source layer 4 port of a packet using a single keyword or numeric notation. To specify the match condition as a single keyword notation, the value for is one of the supported port name keywords (listed below). The currently supported values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number, which is used as both the start and end of a port range. To specify the match condition as a numeric value, one layer 4-port number is required. The port number is an integer from 0 to 65535. Default Format Mode none match srcl4port { | } Class-Map Config Ipv6-Class-Map Config match vlan This command adds to the specified class definition a match condition based on the value of the layer 2 VLAN Identifier field (the 802.1Q tag of a VLAN tagged packet). The VLAN is an integer from 0 to 4095. Default Format Mode none match vlan {} Class-Map Config Ipv6-Class-Map Config Quality of Service (QoS) Commands 460