Netgear M4100-26G CLI Manual - Page 28
interface loopback
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
ProSafe M4100 and M7100 Managed Switches interface loopback Use this command to enter the Interface Config mode for a loopback interface. The range of the loopback ID is 0-7. Format Mode interface loopback Global Config no interface loopback This command removes the loopback interface and associated configuration parameters for the specified loopback interface. Format Mode no interface loopback Global Config show interface loopback This command displays information about configured loopback interfaces. Format Mode show interface loopback [] Privileged EXEC If you do not specify a loopback ID, the following information appears for each loopback interface on the system: Term Loopback ID Interface IP Address Received Packets Sent Packets IPv6 Address Definition The loopback ID associated with the rest of the information in the row. The interface name. The IPv4 address of the interface. The number of packets received on this interface. The number of packets transmitted from this interface. The IPv6 address of this interface. If you specify a loopback ID, the following information appears: Term Definition Interface Link Status Shows whether the link is up or down. IP Address The IPv4 address of the interface. IPv6 is enabled (disabled) Shows whether IPv6 is enabled on the interface. Switching Commands 28