Netgear M4100-26G CLI Manual - Page 683
selects another server for making RADIUS transactions. If the 'auth' token is used,
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 683 highlights
ProSafe M4100 and M7100 Managed Switches Note: To reconfigure a RADIUS accounting server to use the default UDP , set the parameter to 1813. Format Mode radius server host {auth | acct} {} [name ] [port ][server-type] Global Config Field ipaddr dnsname 0-65535 servername Description The IP address of the server. The DNS name of the server. The port number to use to connect to the specified RADIUS server. The alias name to identify the server. no radius server host Use the no version of this command to delete the configured server entry from the list of configured RADIUS servers. If the RADIUS authenticating server being removed is the active server in the servers that are identified by the same server name, then the RADIUS client selects another server for making RADIUS transactions. If the 'auth' token is used, the previously configured RADIUS authentication server is removed from the configuration. Similarly, if the 'acct' token is used, the previously configured RADIUS accounting server is removed from the configuration. The parameter must match the IP address or dns name of the previously configured RADIUS authentication / accounting server. Format Mode no radius server host {auth | acct} {} Global Config The following shows an example of the command. (Switch) (Config) #radius server host acct 192.168.37.60 (Switch) (Config) #radius server host acct 192.168.37.60 port 1813 (Switch) (Config) #radius server host auth 192.168.37.60 name Network1_RADIUS_Auth_Server port 1813 (Switch) (Config) #radius server host acct 192.168.37.60 name Network2_RADIUS_Auth_Server (Switch) (Config) #no radius server host acct 192.168.37.60 Management Commands 683