Netgear M4100-26G CLI Manual - Page 459
match protocol, match source-address mac, match srcip, parameter is any layer 2 MAC address formatted
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 459 highlights
ProSafe M4100 and M7100 Managed Switches Format Mode match ip tos Class-Map Config match protocol This command adds to the specified class definition a match condition based on the value of the IP Protocol field in a packet using a single keyword notation or a numeric value notation. To specify the match condition using a single keyword notation, the value for is one of the supported protocol name keywords. The currently supported values are: icmp, igmp, ip, tcp, udp. A value of ip matches all protocol number values. To specify the match condition using a numeric value notation, the protocol number is a standard value assigned by IANA and is interpreted as an integer from 0 to 255. Note: This command does not validate the protocol number value against the current list defined by IANA. Default Format Mode none match protocol { | } Class-Map Config Ipv6-Class-Map Config match source-address mac This command adds to the specified class definition a match condition based on the source MAC address of a packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (for example, 00:11:22:dd:ee:ff). The parameter is a layer 2 MAC address bit mask, which might not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (for example, ff:07:23:ff:fe:dc). Default Format Mode none match source-address mac Class-Map Config Ipv6-Class-Map Config match srcip This command adds to the specified class definition a match condition based on the source IP address of a packet. The parameter specifies an IP address. The Quality of Service (QoS) Commands 459