Netgear M4100-26G CLI Manual - Page 493
Prioritization Type, show auto-voip
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 493 highlights
ProSafe M4100 and M7100 Managed Switches Note: The administrator has to enable tagging on auto-VoIP-enabled ports to remark the voice data when it is egressed. Format Mode Default auto-voip protocol-based {remark | traffic-class } • Global Config • Interface Config Traffic-class 7 no auto-voip protocol-based {remark | traffic-class} This command is used to set the traffic-class to the default value. Format Mode no auto-voip protocol-based {remark | traffic-class } • Global Config • Interface Config show auto-voip Use this command to display the auto VoIP settings on the interface or interfaces of the switch. Format Mode show auto-voip {protocol-based|oui-based} interface {slot/port|all} Privileged EXEC Field VoIP Prioritize Type Class Value Priority AutoVoIPMode Description The global VoIP VLAN ID. The type of prioritization used on voice traffic. • If the Prioritization Type is configured as traffic-class, this value is the queue value. • If the Prioritization Type is configured as remark, this value is 802.1p priority used to remark the voice traffic. The 802.1p priority. This field is valid for OUI auto VoIP. The Auto VoIP mode on the interface. Example 1: The following shows an example of a CLI display output for the command. (switch)# show auto-voip protocol-based interface all VoIP VLAN Id 2 Prioritization Type traffic-class Class Value 7 Quality of Service (QoS) Commands 493