Netgear M4100-26G CLI Manual - Page 431

ProSafe M4100 and M7100 Managed Switches Term Definition BSR Address IP address of the BSR. Uptime Length of time that this router has been up (in hours, minutes, and seconds). BSR Priority Priority as configured in the ip pim bsr-candidate command. Hash Mask Length Length of a mask (maximum 32 bits) that is to be ANDed with the group address before the hash function is called. This value is configured in the ip pim bsr-candidate command. Next Bootstrap Message In Time (in hours, minutes, and seconds) in which the next bootstrap message is due from this BSR. Next Candidate RP advertisement in Time (in hours, minutes, and seconds) in which the next candidate RP advertisement will be sent. show ipv6 pim rp-hash Use this command to display which rendezvous point (RP) is being used for a specified group. Format Modes show ipv6 pim rp-hash • Privileged EXEC • User EXEC Term RP Origin Definition The IP address of the RP for the group specified. Indicates the mechanism (BSR or static) by which the RP was selected. show ipv6 pim rp mapping Use this command to display all group-to-RP mappings of which the router is aware (either configured or learned from the bootstrap router (BSR)). If no RP is specified, all active RPs are displayed. Format Modes show ipv6 pim rp mapping [rp address] • Privileged EXEC • User EXEC IPv6 MLD Commands IGMP/MLD Snooping is Layer 2 functionality but IGMP/MLD are Layer 3 multicast protocols. It requires that in a network setup there should be a multicast router (which can act as a querier) to be present to solicit the multicast group registrations. However some network setup does not need a multicast router as multicast traffic is destined to hosts within the same IPv6 Multicast Commands 431