Netgear M4100-26G CLI Manual - Page 456
match secondary cos, match ip6flowlbl, match destination-address mac, match dstip, <ipaddr>
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 456 highlights
ProSafe M4100 and M7100 Managed Switches match secondary cos This command adds to the specified class definition a match condition for the secondary Class of Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The value might be from 0 to 7. Default Format Mode none match secondary-cos Class-Map Config match ip6flowlbl This command adds to the specified class definition a match condition based on the IP6flowlbl of a packet. The label is the value to match in the Flow Label field of the IPv6 header (range 0-1048575). Format Mode match ip6flowlbl Ipv6-Class-Map Configuration mode match destination-address mac This command adds to the specified class definition a match condition based on the destination MAC address of a packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (for example, 00:11:22:dd:ee:ff). The parameter is a layer 2 MAC address bit mask, which need not to be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (for example, ff:07:23:ff:fe:dc). Default Format Mode none match destination-address mac Class-Map Config Ipv6-Class-Map Config match dstip This command adds to the specified class definition a match condition based on the destination IP address of a packet. The parameter specifies an IP address. The parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits. Default Format Mode none match dstip Class-Map Config Quality of Service (QoS) Commands 456