Netgear M4100-26G CLI Manual - Page 64
voice vlan data priority, show voice vlan, no voice vlan Interface Config
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
ProSafe M4100 and M7100 Managed Switches Format Mode voice vlan { | dot1p | none | untagged} Interface Config You can configure Voice VLAN in any of the following ways: Parameter vlan-id dot1p none untagged Description Configure the IP phone to forward all voice traffic through the specified VLAN. Valid VLAN IDs are from 1 to 4093 (the maximum supported by the platform). Configure the IP phone to use 802.1p priority tagging for voice traffic and to use the default native VLAN (VLAN 0) to carry all traffic. Valid range is 0-7. Allow the IP phone to use its own configuration to send untagged voice traffic. Configure the phone to send untagged voice traffic. no voice vlan (Interface Config) Use this command to disable the Voice VLAN capability on the interface. Format Mode no voice vlan Interface Config voice vlan data priority Use this command to either trust or untrust the data traffic arriving on the Voice VLAN port. Default Format Mode trust voice vlan data priority {untrust | trust} Interface Config show voice vlan Format Mode show voice vlan [interface { | all}] Privileged EXEC When the interface parameter is not specified, only the global mode of the Voice VLAN is displayed. Term Administrative Mode Definition The Global Voice VLAN mode. Switching Commands 64