Netgear M4100-26G CLI Manual - Page 18

ProSafe M4100 and M7100 Managed Switches enable help logout ping quit show telnet Enter into user privilege mode. Display help for various special keys. Exit this session. Any unsaved changes are lost. Send ICMP echo packets to a specified IP address. Exit this session. Any unsaved changes are lost. Display Switch Options and Settings. Telnet to a remote host. Enter a question mark (?) after each word you enter to display available command keywords or parameters. (switch) #network ? javamode mgmt_vlan parms protocol Enable/Disable. Configure the Management VLAN ID of the switch. Configure Network Parameters of the router. Select DHCP, BootP, or None as the network config protocol. If the help output shows a parameter in angle brackets, you must replace the parameter with a value. (switch) #network parms ? Enter the IP address. If there are no additional command keywords or parameters, or if more parameters are optional, the following message appears in the output: Press Enter to execute the command You can also enter a question mark (?) after typing one or more characters of a word to list the available command or parameters that begin with the letters, as shown in the following example: (switch) #show m? mac-addr-table mac-address-table monitor Accessing the CLI You can access the CLI by using a direct console connection or by using a telnet or SSH connection from a remote management host. For the initial connection, you must use a direct connection to the console port. You cannot access the system remotely until the system has an IP address, subnet mask, and default gateway. You can set the network configuration information manually, or you can configure the system to accept these settings from a BOOTP or DHCP server on your network. For more information, see Network Interface Commands on page 626. Using the Command-Line Interface 18