Netgear M4100-26G CLI Manual - Page 356

ProSafe M4100 and M7100 Managed Switches Tunnel Interface Commands The commands in this section describe how to create, delete, and manage tunnel interfaces. Several different types of tunnels provide functionality to facilitate the transition of IPv4 networks to IPv6 networks. These tunnels are divided into two classes: configured and automatic. The distinction is that configured tunnels are explicitly configured with a destination or endpoint of the tunnel. Automatic tunnels, in contrast, infer the endpoint of the tunnel from the destination address of packets routed into the tunnel. To assign an IP address to the tunnel interface, see ip address on page 228. To assign an IPv6 address to the tunnel interface, see ipv6 address on page 359. interface tunnel Use this command to enter the Interface Config mode for a tunnel interface. The range is 0-7. Format Mode interface tunnel Global Config no interface tunnel This command removes the tunnel interface and associated configuration parameters for the specified tunnel interface. Format Mode no interface tunnel Global Config tunnel source This command specifies the source transport address of the tunnel, either explicitly or by reference to an interface. Format Mode tunnel source { | ethernet } Interface Config tunnel destination This command specifies the destination transport address of the tunnel. Format Mode tunnel destination {} Interface Config IPv6 Commands 356