Netgear M4100-26G CLI Manual - Page 548

ProSafe M4100 and M7100 Managed Switches of the traceroute. This port should be an unused port on the destination system. The range for is zero (0) to 65535. The default value is 33434. Default Format Mode port: 33434 traceroute ipv6 [port ] Privileged EXEC clear config This command resets the configuration to the factory defaults without powering off the switch. When you issue this command, a prompt appears to confirm that the reset should proceed. When you enter y, you automatically reset the current configuration on the switch to the default values. It does not reset the switch. Format Mode clear config Privileged EXEC clear eventlog This command clears all event messages maintained in the switch. Format Mode clear eventlog Privileged EXEC clear mac-addr-table This command clears the dynamically learned MAC addresses of the switch. Format Mode clear mac-addr-table Privileged EXEC clear logging buffered This command clears the messages maintained in the system log. Format Mode clear logging buffered Privileged EXEC Utility Commands 548