Netgear M4100-26G CLI Manual - Page 96
storm-control broadcast rate
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
ProSafe M4100 and M7100 Managed Switches no storm-control broadcast level This command sets the broadcast storm recovery threshold to the default value for an interface and disables broadcast storm recovery. Format Mode no storm-control broadcast level Interface Config storm-control broadcast rate Use this command to configure the broadcast storm recovery threshold for an interface in packets per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold. Default Format Mode 0 storm-control broadcast rate Interface Config no storm-control broadcast rate This command sets the broadcast storm recovery threshold to the default value for an interface and disables broadcast storm recovery. Format Mode no storm-control broadcast rate Interface Config storm-control broadcast (Global) This command enables broadcast storm recovery mode for all interfaces. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic will be limited to the configured threshold. Default Format Mode disabled storm-control broadcast Global Config no storm-control broadcast This command disables broadcast storm recovery mode for all interfaces. Format Mode no storm-control broadcast Global Config Switching Commands 96