Netgear M4100-26G CLI Manual - Page 400
External LSDB, Active Areas
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 400 highlights
ProSafe M4100 and M7100 Managed Switches Term Definition Maximum Number of Retransmit Entries The maximum number of LSAs that can be waiting for acknowledgment at any given time. Retransmit Entries High Water Mark The highest number of LSAs that have been waiting for acknowledgment. External LSDB Limit The maximum number of non-default AS-external-LSAs entries that can be stored in the link-state database. Default Metric Default value for redistributed routes. Default Passive Shows whether the interfaces are passive by default. Setting Default Route Advertise Indicates whether the default routes received from other source protocols are advertised or not. Always Shows whether default routes are always advertised. Metric The metric for the advertised default routes. If the metric is not configured, this field is blank. Metric Type Shows whether the routes are External Type 1 or External Type 2. Number of Active Areas The number of active OSPF areas. An "active" OSPF area is an area with at least one interface up. AutoCost Ref BW Shows the value of the auto-cost reference bandwidth configured on the router. Maximum Paths The maximum number of paths that OSPF can report for a given destination. Redistributing This field is a heading and appears only if you configure the system to take routes learned from a non-OSPF source and advertise them to its peers. Source Shows source protocol/routes that are being redistributed. Possible values are static, connected, BGP, or RIP. Metric The metric of the routes being redistributed. Metric Type Shows whether the routes are External Type 1 or External Type 2. Tag The decimal value attached to each external route. Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol. Distribute-List The access list used to filter redistributed routes. IPv6 Commands 400