Netgear M4100-26G CLI Manual - Page 360

ProSafe M4100 and M7100 Managed Switches ipv6 address autoconfig This command is used to enable stateless address autoconfiguration capability. Note: When unicast-routing is enabled, autoconfig mode does not work. Format Mode ipv6 address autoconfig Interface Config ipv6 address autoconfig This command disables the stateless autoconfiguration. Format Mode no ipv6 address autoconfig Interface Config ipv6 address dhcp This command is used to enable DHCPv6 client capability. Format Mode ipv6 address autoconfig Interface Config no pv6 address dhcp The "no" form of this command disables the DHCPv6 client capability. Format Mode no ipv6 address autoconfig Interface Config ipv6 route Use this command to configure an IPv6 static route. The is the IPv6 network that is the destination of the static route. The is the length of the IPv6 prefix - a decimal value (usually 0-64) that shows how many of the high-order contiguous bits of the address comprise the prefix (the network portion of the address). A slash mark must precede the . The is the IPv6 address of the next hop that can be used to reach the specified network. Specifying Null0 as nexthop parameter adds a static reject route. The parameter is a value the router uses to compare this route with routes from other route sources that have the same destination. The range for is 1 - 255, and the default value is 1. You can specify a or tunnel interface to identify direct static routes from point-to-point and broadcast interfaces. The interface must be specified when IPv6 Commands 360