Netgear M4100-26G CLI Manual - Page 629
Console Port Access Commands, configuration, serial baudrate
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 629 highlights
ProSafe M4100 and M7100 Managed Switches IPv6 Address/Length is 3099::210:18FF:FE82:337/64 IPv6 Default Router is FE80::204:76FF:FE73:423A Burned In MAC Address 00:10:18:82:03:37 Locally Administered MAC Address 00:00:00:00:00:00 MAC Address Type Burned In Network Configuration Protocol Current......... None Management VLAN ID 1 Web Mode Enable Java Mode Enable Console Port Access Commands This section describes the commands you use to configure the console port. You can use a serial cable to connect a management host directly to the console port of the switch. configuration Use this command to access Global Config mode. From Global Config mode, you can configure various system settings, including user accounts. You can also enter other command modes, including Line Config mode. Format Mode configuration Privileged EXEC line Use this command to access Line Config mode, which allows you to configure various Telnet settings, ssh settings, and the console port. Format Mode line {console | telnet | ssh} Global Config serial baudrate Use this command to specify the communication rate of the terminal interface. The supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200. Default Format Mode 115200 serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200} Line Config Management Commands 629