Netgear M4100-26G CLI Manual - Page 737

ProSafe M4100 and M7100 Managed Switches clear green-mode statistics This command to clears the following for a specified , or for all ports: • EEE LPI event count, and LPI duration • EEE LPI history table entries • Cumulative Power savings estimates Format Mode clear green-mode statistics { | all} Privileged Exec Example (switch) #clear green-mode statistics 0/1 Are you sure you want to clear the green mode port stats? (y/n)y Green Mode Stats Cleared. (switch) #clear green-mode statistics all Are you sure you want to clear the green mode port stats? (y/n)y Green Mode Stats Cleared. show green-mode This command displays green mode configuration and operational status of a port. This command can also display the per port configuration and operational status of the green-mode. The status is shown only for the modes supported on the switch. Format Mode show green-mode Privileged Exec Table 57. Green-Mode status terms Term Definition Energy-detect admin mode Energy-detect mode is enabled or disabled. Energy-detect operational status Energy detect mode is currently active or inactive. The energy detect mode might be administratively enabled, but the operational status might be inactive. The reasons for the same are described below. Reason for Energy-detect The energy detect mode might be administratively enabled, but the operational current operational status status might be inactive. The reasons for the same are: - Port is currently operating in the fiber mode - Link is up. - Admin Mode Disabled - Interface Not Attached If the energy-detect operational status is active, the reason field displays No energy Detected Green Ethernet Commands 737