Netgear M4100-26G CLI Manual - Page 724

ProSafe M4100 and M7100 Managed Switches Table 38. DiffServ Log Messages Component DiffServ DiffServ Message Cause diffserv.c 165: diffServRestore Failed to reset DiffServ. Recommend resetting device While attempting to clear the running configuration an error was encountered in removing the current settings. This might lead to an inconsistent state in the system and resetting is advised. Policy invalid for service intf: "policy name, intIfNum x, direction y The DiffServ policy definition is not compatible with the capabilities of the interface specified. Check the platform release notes for information about configuration limitations. Routing/IPv6 Routing Table 39. DHCP Relay Log Messages Component DHCP relay DHCP relay DHCP relay Message Cause REQUEST hops field more than config value The DHCP relay agent has processed a DHCP request whose HOPS field is larger than the maximum value allowed. The relay agent will not forward a message with a hop count greater than 4. Request's seconds field less than the config value The DHCP relay agent has processed a DHCP request whose SECS field is larger than the configured minimum wait time allowed. processDhcpPacket: invalid DHCP packet The DHCP relay agent has processed an type: %u\n invalid DHCP packet. Such packets are discarded by the relay agent. Table 40. OSPFv2 Log Messages Component OSPFv2 Message Best route client deregistration failed for OSPF Redist OSPFv2 XX_Call() failure in _checkTimers for thread 0x869bcc0 Cause OSPFv2 registers with the IPv4 routing table manager ("RTO") to be notified of best route changes. There are cases where OSPFv2 deregisters more than once, causing the second deregistration to fail. The failure is harmless. An OSPFv2 timer has fired but the message queue that holds the event has filled up. This is normally a fatal error. Log Messages 724