Netgear M4100-26G CLI Manual - Page 438
ipv6 mld-proxy, ipv6 mld-proxy unsolicit-rprt-interval, ipv6 mld-proxy reset-status
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 438 highlights
ProSafe M4100 and M7100 Managed Switches ipv6 mld-proxy Use this command to enable MLD-Proxy on the router. To enable MLD-Proxy on the router, you must enable multicast forwarding. Also, make sure that there are no other multicast routing protocols enabled n the router. Format Mode ipv6 mld-proxy Interface Config no ipv6 mld-proxy Use this command to disable MLD-Proxy on the router. Format Mode no ipv6 mld-proxy Interface Config ipv6 mld-proxy unsolicit-rprt-interval Use this command to set the unsolicited report interval for the MLD-Proxy router. This command is only valid when you enable MLD-Proxy on the interface. The value of is 1-260 seconds. Default Format Mode 1 ipv6 mld-proxy unsolicit-rprt-interval Interface Config no ipv6 mld-proxy unsolicited-report-interval Use this command to reset the MLD-Proxy router's unsolicited report interval to the default value. Format Mode no ipv6 mld-proxy unsolicit-rprt-interval Interface Config ipv6 mld-proxy reset-status Use this command to reset the host interface status parameters of the MLD-Proxy router. This command is only valid when you enable MLD-Proxy on the interface. Format Mode ipv6 mld-proxy reset-status Interface Config IPv6 Multicast Commands 438