Netgear M4100-26G CLI Manual - Page 539

ProSafe M4100 and M7100 Managed Switches Term Definition Number of Traps Since Last Reset The number of traps since the last boot. Trap Log Capacity The number of traps the system can retain. Number of Traps Since Log The number of new traps since the command was last executed. Last Viewed Log The log number. System Time Up How long the system had been running at the time the trap was sent. Trap The text of the trap message. logging persistent Use this command to configure the Persistent logging for the switch. The severity level of logging messages is specified at severity level. Possible values for severity level are (emergency|0, alert|1, critical|2, error|3, warning|4, notice|5, info|6, debug|7). Default Format Mode Disable logging persistent Global Config no logging persistent Use this command to disable the persistent logging in the switch. Format Mode no logging persistent Global Config Email Alerting and Mail Server Commands logging email This command enables email alerting and sets the lowest severity level for which log messages are emailed. If you specify a severity level, log messages at or above this severity level, but below the urgent severity level, are emailed in a non-urgent manner by collecting them together until the log time expires. You can specify the severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7). Default Disabled; when enabled, log messages at or above severity Warning (4) are emailed Utility Commands 539