Netgear M4100-26G CLI Manual - Page 675

ProSafe M4100 and M7100 Managed Switches no snmp-server enable traps multiusers Use this command to disable Multiple User traps. Format Mode no snmp-server enable traps multiusers Global Config snmp-server enable traps stpmode Use this command to enable sending new root traps and topology change notification traps. Default Format Mode enabled snmp-server enable traps stpmode Global Config no snmp-server enable traps stpmode Use this command to disable sending new root traps and topology change notification traps. Format Mode no snmp-server enable traps stpmode Global Config snmptrap Use this command to add an SNMP trap receiver. The maximum length of is 16 case-sensitive alphanumeric characters. The is the version of SNMP. The version parameter options are snmpv1 or snmpv2. The SNMP trap address can be set using both an IPv4 address format as well as an IPv6 global address format. The following shows an example of the CLI command. (Netgear Switch)# snmptrap mytrap ip6addr 3099::2 Note: The parameter does not need to be unique, however; the and pair must be unique. Multiple entries can exist with the same , as long as they are associated with a different . The reverse scenario is also acceptable. The is the community name used when sending the trap to the receiver, but the is not directly associated with the SNMP Community Table, See "snmp-server community" on page39." Management Commands 675