Netgear M4100-26G CLI Manual - Page 229
ip address dhcp, ip default-gateway
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
ProSafe M4100 and M7100 Managed Switches Parameter ipaddr subnetmask prefix-length Description The IP address of the interface. A four-digit dotted-decimal number that represents the subnet mask of the interface Implements RFC 3021. Using the / notation of the subnet mask, this is an integer that indicates the length of the subnet mask. Range is 5-32 bits. no ip address This command deletes an IP address from an interface. The value for is the IP address of the interface in a.b.c.d format where the range for a, b, c, and d is 1-255. The value for is a 4-digit dotted-decimal number which represents the Subnet Mask of the interface. To remove all of the IP addresses (primary and secondary) configured on the interface, enter the command no ip address. Format Mode no ip address [{ [secondary]}] Interface Config ip address dhcp Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire network information, such as the IP address, subnet mask, and default gateway from a network DHCP server. When DHCP is enabled on the interface, the system automatically deletes all manually configured IPv4 addresses on the interface. Default Format Mode disabled ip address dhcp Interface Config no ip address dhcp Use this command to release a leased address and disable DHCPv4 on an interface. Format Mode no ip address dhcp Interface Config ip default-gateway Use this command to manually configure a default gateway for the switch. Only one default gateway can be configured. If you use this command multiple times, each command replaces the previous value. Format Mode ip default-gateway Global Config Routing Commands 229