Netgear M4100-26G CLI Manual - Page 257
DHCP and BOOTP Relay Commands, show ip vrrp interface, bootpdhcprelay cidoptmode
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
ProSafe M4100 and M7100 Managed Switches Advertisement Interval (secs 1 Pre-empt Mode Enable Administrative Mode Disable Accept Mode Enable State Initialized Track Interface State DecrementPriority 0/1> down 10 TrackRoute (pfx/len) StateDecrementPriority 10.10.10.1/255.255.255.0 down 10 show ip vrrp interface This command displays information about each virtual router configured on the switch. This command takes no options. It displays information about each virtual router. Format Modes show ip vrrp interface brief • Privileged EXEC • User EXEC Term Interface VRID IP Address Mode State Definition Valid slot and port number separated by forward slashes. The router ID of the virtual router. The virtual router IP address. Indicates whether the virtual router is enabled or disabled. The state (Master/backup) of the virtual router. DHCP and BOOTP Relay Commands This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies between clients and servers when they are not on the same physical subnet. bootpdhcprelay cidoptmode This command enables the circuit ID option mode for BootP/DHCP Relay on the system. Default Format Mode disabled bootpdhcprelay cidoptmode Global Config Routing Commands 257