Netgear M4100-26G CLI Manual - Page 739

ProSafe M4100 and M7100 Managed Switches Table 57. Green-Mode status terms Term Tx_dll_ready Rx_dll_enabled Rx_dll_ready Cumulative Energy Saving Time Since Counters Last Cleared Definition Data Link Layer ready: This variable indicates that the tx system initialization is complete and is ready to update/receive LLDPDU containing EEE TLV. This variable is updated by the local system software. Status of the EEE capability negotiation on the local system. Data Link Layer ready: This variable indicates that the rx system initialization is complete and is ready to update/receive LLDPDU containing EEE TLV. This variable is updated by the local system software. Estimated Cumulative energy saved on this port in (Watts * hours) due to all green modes enabled Time Since Counters Last Cleared (since the time of power up, or after 'clear eee counters' is executed) Note: Executing 'clear green-mode statistics' only clears the EEE Transmit, Receive LPI event count, LPI duration, and Cumulative Energy Savings Estimates of the port. Other status parameters listed in above table will remain unaffected after 'clear green-mode statistics'. Example: The output of 'show green-mode ' is indicated below. (switch) #show green-mode 0/25 EEE Admin Mode Enabled Transmit Idle Time 0 Transmit Wake Time 0 Rx Low Power Idle Event Count 0 Rx Low Power Idle Duration (uSec).......... 0 Tx Low Power Idle Event Count 0 Tx Low Power Idle Duration (uSec).......... 0 Tw_sys_tx (usec XX Tw_sys_tx Echo (usec XX Tw_sys_rx (usec XX Tw_sys_rx Echo (usec XX Fallback Tw_sys (usec XX Tx DLL enabled Yes Tx DLL ready Yes Rx DLL enabled Yes Rx DLL ready Yes Green Ethernet Commands 739