Netgear M4100-26G CLI Manual - Page 61
dvlan-tunnel ethertype, mode dot1q-tunnel
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
ProSafe M4100 and M7100 Managed Switches dvlan-tunnel ethertype This command configures the ether-type for all interfaces. The ether-type may have the values of 802.1Q, vMAN, or custom. If the ether-type has a value of custom, the optional value of the custom ether type must be set to a value from 0 to 65535. Default Format Mode vman dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535] Global Config mode dot1q-tunnel This command is used to enable Double VLAN Tunneling on the specified interface. Default Format Mode disabled mode dot1q-tunnel Interface Config no mode dot1q-tunnel This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN Tunneling is disabled. Format Mode no mode dot1q-tunnel Interface Config mode dvlan-tunnel Use this command to enable Double VLAN Tunneling on the specified interface. Note: When you use the mode dvlan-tunnel command on an interface, it becomes a service provider port. Ports that do not have double VLAN tunneling enabled are customer ports. Default Format Mode disabled mode dvlan-tunnel Interface Config Switching Commands 61