Netgear M4100-26G CLI Manual - Page 461

ProSafe M4100 and M7100 Managed Switches match secondary-vlan This command adds to the specified class definition a match condition based on the value of the layer 2 secondary VLAN Identifier field (the 802.1Q tag of a double VLAN tagged packet). The VLAN is an integer from 0 to 4095. Default Format Mode none match secondary-vlan {} Class-Map Config Ipv6-Class-Map Config DiffServ Policy Commands Use the DiffServ policy commands to specify traffic conditioning actions, such as policing and marking, to apply to traffic classes Use the policy commands to associate a traffic class that you define by using the class command set with one or more QoS policy attributes. Assign the class/policy association to an interface to form a service. Specify the policy name when you create the policy. Each traffic class defines a particular treatment for packets that match the class definition. You can associate multiple traffic classes with a single policy. When a packet satisfies the conditions of more than one class, preference is based on the order in which you add the classes to the policy. The first class you add has the highest precedence. This set of commands consists of policy creation/deletion, class addition/removal, and individual policy attributes. Note: The only way to remove an individual policy attribute from a class instance within a policy is to remove the class instance and re-add it to the policy. The values associated with an existing policy attribute can be changed without removing the class instance. The CLI command root is policy-map. assign-queue This command modifies the queue id to which the associated traffic stream is assigned. The queueid is an integer from 0 to n-1, where n is the number of egress queues supported by the device. Format Mode Incompatibilities assign-queue Policy-Class-Map Config Drop Quality of Service (QoS) Commands 461