Netgear M4100-26G CLI Manual - Page 547

ProSafe M4100 and M7100 Managed Switches Parameter interval count port size source Description Use interval to specify the time between probes, in seconds. Range is 1-60 seconds. Use the optional count parameter to specify the number of probes to send for each TTL value. Range is 1-10 probes. Use the optional port parameter to specify destination UDP port of the probe. This should be an unused port on the remote destination system. Range is 1-65,535. Use the optional size parameter to specify the size, in bytes, of the payload of the Echo Requests sent. Range is 0-65507 bytes. Use the optional source parameter to specify the source IP address or interface for the traceroute. The following are examples of the CLI command. traceroute Success: (Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 10.240.10.115 ,4 hops max 43 byte packets: 1 10.240.4.1 708 msec 41 msec 11 msec 2 10.240.10.115 0 msec 0 msec 0 msec Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6 traceroute Failure: (Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 10.40.1.1 ,30 hops max 43 byte packets: 1 10.240.4.1 19 msec 18 msec 9 msec 2 10.240.1.252 0 msec 0 msec 1 msec 3 172.31.0.9 277 msec 276 msec 277 msec 4 10.254.1.1 289 msec 327 msec 282 msec 5 10.254.21.2 287 msec 293 msec 296 msec 6 192.168.76.2 290 msec 291 msec 289 msec 7 0.0.0.0 0 msec * Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18 traceroute ipv6 Use the traceroute command to discover the routes that packets actually take when traveling to their destination through the network on a hop-by-hop basis. The parameter must be a valid IPv6 address or hostname. The optional parameter is the UDP port used as the destination of packets sent as part Utility Commands 547