Netgear M4100-26G CLI Manual - Page 314

ProSafe M4100 and M7100 Managed Switches no distribute-list out This command is used to specify the access list to filter routes received from the source protocol. Format Mode no distribute-list out {ospf | static | connected} Router RIP Config ip rip authentication This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The value of is either none, simple, or encrypt. The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of is encrypt, a keyid in the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an authentication key or authentication key ID. Default Format Mode none ip rip authentication {none | {simple } | {encrypt }} Interface Config no ip rip authentication This command sets the default RIP Version 2 Authentication Type for an interface. Format Mode no ip rip authentication Interface Config ip rip receive version This command configures the interface to allow RIP control packets of the specified version(s) to be received. The value for is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP version 2, both to receive packets from either format, or none to not allow any RIP control packets to be received. Default Format Mode both ip rip receive version {rip1 | rip2 | both | none} Interface Config Routing Commands 314